Document - 2.pdf

Certificate: 70055917

70055917

Project: 70055917

70055917

Master Contract: 26 881

Date Issued: March 2, 2016

DQD 507 Rev. 2012-05-22

Page 2

This certification program does not include concrete pipes.

Some provinces in Canada reference ASTM standards as the compliance standards for these products, this

report covers certification in Canada for the ASTM standards referenced below.

APPLICABLE REQUIREMENTS

ASTM Standard C478M – Standard Specification for Circular Precast Reinforced Concrete Manhole Sections

ASTM Standard C139

– Standard Specification for Concrete Masonry Units for Construction of Catch

Basins and Manholes

MARKINGS

The manufacturer is required to apply the following markings:



Products shall be marked with the markings specified by the particular product standard.



Products certified for Canada shall have all Caution and Warning markings in both English and French.

Additional bilingual markings not covered by the product standard(s) may be required by the Authorities Having

Jurisdiction. It is the responsibility of the manufacturer to provide and apply these additional markings, where

applicable, in accordance with the requirements of those authorities.

Individual circular reinforced concrete manhole sections and catch basins shall be legibly marked with the

following information, in a permanent manner, either on the product or on a tag attached to the product, or on the

documentation accompanying the product (provided the latter is cross-referenced with the documentation), or by

any other means acceptable to CSA Group:

Manufacturer's name, trade name, trademark, or CSA file number;

Specification and product designation: MH for manhole base, riser, conical tops, and grade rings;

Date of manufacturing; and

CSA Mark.

Marking shall be indented into the concrete at the time of manufacturing or shall be painted thereon with

waterproof paint or ink. Certain jurisdictions in Canada require the use of French language in markings. It is the

responsibility of the manufacturer to determine where this is required